Call our team now on : +44 (0)8453 62 63 65

New range of DC electronic loads from Magna-Power


Magna-Power Electronics, has recently released its MagnaLOAD product line of DC electronic loads spanning 1.25 kW to 120 kW+.

The new product line includes 3 product series, ALx Series, ARx Series, and WRx Series spanning 39 air- and water-cooled models from 1.25 kW to 120 kW+ with voltage ranges up to 0-1,000 Vdc and current ranges up to 0-1,200 Adc.

The MagnaLOAD product line launches with Magna-Power’s all new distributed DSP architecture, MagnaLINK™, featuring digital control loops and an internally developed high-speed product-to-product communication protocol.

The MagnaLOAD product line is designed to dissipate DC power during development, manufacturing, and validation of DC sources, including: power supplies, DC-DC converters, batteries, solar panels, fuel cells, motors, and electromagnets.

ALx Series MagnaLOAD

The ALx Series MagnaLOAD, 1.25 kW and 2.5 kW, uses conventional linear MOSFET-based dissipative elements, allowing the series to achieve a very wide voltage-current operating range within a model’s maximum power rating. Using the same heat management innovations developed for Magna-Power’s high density programmable DC power supplies, the ALx Series’ conservative cooling ensures long product life in environments up to 50 C ambient operating temperature.

ARx Series MagnaLOAD

The ARx Series MagnaLOAD, 7.5 kW to 45 kW+, introduces Magna-Power’s patent-pending Active Resistance Technology, combining a binary switched resistor network in series with linear elements. Used in conjunction with the new MagnaLINK™ DSP controller, the ARx Series achieves 16-bit programming and measurement resolution and, as a result of the Active Resistance Technology, at a fraction of the price of traditional electronic loads. As well as typical voltage, current, power, and resistance control modes, the Active Resistance Technology enables the product’s Rheostat control mode, providing direct on-the-fly control of internal binary resistor network, avoiding control bandwidth constraints typically experienced with resistance control modes.

WRx Series MagnaLOAD

The WRx Series MagnaLOAD, 15 kW to 120 kW+, also uses Magna-Power’s new Active Resistance Technology in combination with the company’s newly developed internally manufactured microchannel water-cooled heatsinks. Designed for high-power applications where heat-flow control is essential, the WRx Series greatly increases power density compared air-cooled alternatives. An integrated solenoid controls the flow of water to avoid condensation. Full power can be achieved using conventional water with water inlet temperatures up to 25 C.


MagnaLINK™, Magna-Power’s next generation control architecture, provides a distributed network of DSPs across the major assemblies in its programmable DC products. Beyond Magna-Power’s standard fast transient response and high accuracy programming and measurement, MagnaLINK™ adds: fully digital control loops, adjustable control gains, programmable slew rates, arbitrary waveform generation, among many new advanced control technologies. Expandability is at the forefront with MagnaLINK™, providing buffered digital master-slaving MagnaLINK™ ports, allowing many units to be added in parallel or series with uncompromised performance and aggregated DC input measurements.

All MagnaLOAD products come standard with front and rear full control (host) USB ports, RS485, dual MagnaLINK™ ports for digital master-slaving, and a 25-pin D-Sub external user I/O connector with configurable pin mappings; LXI TCP/IP Ethernet and IEEE-488 GPIB interfaces are also available. Many different programming environments are supported via Standard Commands for Programmable Instrumentation (SCPI), and provided National Instruments LabVIEW™ and IVI drivers.

Some features may not be available at launch, but will be available at a future date through a firmware update.

For further information and details on pricing please call +44 (0)8453 62 63 65 or email